Eizo AAH-02B3W User Manual
Page 2
Method of Installing the product
Method of Assembling a Monitor
Guarantee & After-sale Service
5
6
Modulating Method consequent
on the weight of the monitor
7
8
Putting the monitor at the bottom with its
back side up and tighten the fixing bolts to
the VESA hole like the
tighten the four pieces of fixing bolts.
The fixing bolts to the
monitor have two sizes ; one
is 4x12mm, and the other is
4x16mm. Use the size to the
monitor.
Insert the ARM HINGE into the gap of the
fixing bracket on the wall . At the time of
inserting it, be careful about the
direction of ARM HINGE.
With the tightening of the knob bolts
to the hole like the
installaton job is done.
Fixing Bracket on the wall
after complete
After inserting the anchor
bolts for fixing into four
spots fit in with the hole as
specified in the picuture,
please press the product to
the hole which is inserted
by the anchor bolts for
fixing.
Please tighten the fixing bolts
to the hole using a philips
screwdriver. The installation
job is finished with the
tightening the fixing bolts at
four spots so that the bolts can
be completely pressed to the
wall.
After attaching a drawing
to the spot where the
product is installed, please
mark the four spots of
anchor bolts.
Using the drill bit of 6-mm
diameter at the spot marked
on the wall where anchor
bolts are, drill a hole within
the length of 55 mm.
At the time of installing the product, first , confirm
whether the wall materials meet the condition after
definitely
Don't install this product at glass, thin wood or the
wall thinner than 60mm.
This product is applicable to the monitor with the weight from
3kg
to
the
maximum
7kg.
Modulating wrench
4mm
Modulate the part for modulation
using a wrench like
1
2
You can use 4-mm-wrench for
modulation as showing in
by modulating "+" or "-" like
When changing the monitor from
19 inches to 22 inches, you can
modulate it like the drawing beside.
You can use it in accord with the
weight of the monitor.
Please, detach the attached
drawing, and clean the
drilled hole.
The span between holes for installing this product is 100x100, or 75x 75mm
based on the size standard. Completely tighten the VESA Assembly of the
monitor using 4 fixing bolts to the size 100x100 or 75x75 for the assembly
job.
●
●
●
Cautions
http://www.eizo.com