Digi-Star TMR Tracker - Manual (Page 4)

Note that the right part of this screen is not available in DataLink, as the DataLink program composes Mixer Loads.
3. Normally, this screen consists of 2 or 3 parts; at the left panel an overview of the feeding periods and mixers and in
the center panel all groups with feeding data is shown. In the right panel, the actual Mixer Loads have been
composed. The left panel may not be visible in case of a single mixer & single feeding situation, then only 2 panels
are available. Before sending the data to the DataKey / DataLink file, you can check a number of things.
• Check load composition: Press the expand or collapse button in front of a mixer load to view which deliveries
are in the load. Use the expand all or collapse all buttons to control the grid with a single mouse-click.
• Feeding Order: Move groups up / down with the arrow-keys & . Don't forget to save the feeding order if you
want to re-use this order the next time: .
4. Before sending the loads, you'll have to set Communication Settings. Press the button 'Settings' in the left bottom
to open the communication-settings screen. On the tab 'Communication', complete the configuration (either com-
port setup for DataKey or output folder setup for DataLink). Press Ok to return to the 'Send Data' screen.
5. Press the 'Send All Loads' button to send the data to the DataKey or DataLink-file. After sending the data, you can
close the screen and continue with the feeding process.
Hint: During your first days, it may be comfortable to print the load sheet (Print Preview) and use it as a backup in
order to get acquainted with the Indicator menu.