DFI OT951-D series - Manual (Page 35)

35
2
Hardware Installation
SATA 0
SATA (Serial ATA) Connectors
7
RXN
GND
TXP
TXN
GND
1
RXP
GND
SATA 3.0 6Gb/s
Features
• 1 Serial ATA port
- SATA 3.0 port with data transfer rate up to 6Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
• Supports RAID 0, RAID 1, RAID 5 and RAID 10
SATA power
+5V
Ground
+12V
Ground
1
4
BIOS Setting
Confi gure the Serial ATA drives in the Integrated Peripherals submenu (“OnChip
IDE Device” section) of the BIOS. Refer to chapter 3 for more information.
The Serial ATA connectors are used to connect Serial ATA devices. Connect one
end of the Serial ATA data cable to a SATA connector and the other end to your
Serial ATA device.
The system board package comes with a power cable that must be connected
from the system board’s peripheral power connector to the SATA drive’s power
connector in order to provide power to the drive.
Connect to the peripheral
power connector
Connect to the
SATA drive
Connect to the
SATA port