DFI G5C900-B - Manual (Page 14)

COM Express Board
14
9. If the board already comes installed with the heat sink / fan
assembly, you will still be able to install the module without re-
moving the heat sink / fan assembly. Avoid constant removal and
installation of the assembly as this will easily damage the compo-
nents on the board.
Despite limited space to accessing the SODIMM socket, installing
the module is basically the same as described earlier.
a) Inser t the module into
the socket at an approxi-
mately 30 degrees angle.
b) Push down the module
until the clips at each side
of the socket lock into
position.
c) To remove the module,
simultaneously push the
retaining clips outward to
unlock the module. You
can also use a thin blunt
object to push the clips
outward. The module will
release from the socket.