Devolo dLAN 200 AVplus - Manual (Page 18)

Initial use 17
devolo dLAN 200 AVplus
Please note that all dLAN AV devices
to be connected to your network are
also connected to your household
electrical wiring. A dLAN AV device
switches to Standby mode after a
short while if no active network de-
vice such as a computer is connected
to the network port. In Standby mode,
the dLAN AV device cannot be acces-
sed via the power supply grid. As soon
as the network device (e.g. computer)
connected to the network interface is
switched on again, your dLAN AV de-
vice can also be reached again via the
electrical wiring.
3.4 Connecting the
dLAN 200 AVplus
This section describes how to connect your
dLAN 200 AVplus to a computer or other network de-
vice.
ቢ Use the included network cable to connect the
dLAN 200 AVplus to the network port of your run-
ning computer or other network device.
ባ Plug the dLAN 200 AVplus into a free electrical
outlet.
Additional network devices that are connec-
ted via a multiple socket are connected to the
mains power supply by plugging the multiple
socket into the integrated electrical socket of
the dLAN 200 AVplus.
ቤ Once you have connected at least two
dLAN 200 AVplus adapters as described above,
your dLAN 200 AVplus network has been set up.
To secure your dLAN AV network, continue with
the configuration as described in chapter 4 dLAN
network.
3.5 Software installation
3.5.1 Software for Windows
Use the installation wizard to install the devolo soft-
ware for using the adapter with the Windows opera-
ting system:
b devolo dLAN Cockpit finds all reachable dLAN
adapters in your dLAN AV network, displays infor-
mation about these devices and encrypts your
dLAN AV network individually.
To install the software, insert the included CD-ROM in
the CD drive of your computer.