Devolo dLAN 550 duo+ - Manual (Page 16)

Installation 15
devolo dLAN 550 duo+
gnificantly improves data transmission in the home
network.
Please note that all dLAN devices to
be connected to your network are
also connected to your household
electrical wiring. A dLAN device
switches to Standby mode after a
short while if no active network de-
vice such as a computer is connected
to the network port. In Standby
mode, the dLAN device cannot be ac-
cessed via the power supply grid. As
soon as the network device (e.g.
computer) connected to the network
interface is switched on again, your
dLAN device can also be reached
again via the electrical wiring.
3.4 Connecting the dLAN 550 duo+
This section describes how to connect your
dLAN 550 duo+ to a computer and/or other network
device.
For the permitted voltage range for
operating the device and the power
consumption, refer to the label on
the rear side of the device.
Additional technical information is
available in the download area at
www.devolo.com .
ቢ Use the included network cable to connect the
dLAN 550 duo+ to the network port of your run-
ning computer and/or other network device.
Prevent tripping hazards when ca-
bling.
ባ Plug the dLAN 550 duo+ into a free electrical out-
let.
The power outlet and all connected
network devices should be easily ac-
cessible so that you can pull the
mains plug quickly if needed.
To disconnect the adapter from the
mains supply, pull the device itself or
its mains plug from the power outlet.