Daktronics All Sport 5000 Series Quick Start Guide - Manual (Page 4)

All Sport 5000 Series Console Quick Start Guide 4 of 4
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700
Web: www.daktronics.com/allsportsupport
DD2077845 Rev 1
26 July 2012
Jacks & Switches

J1- J3 (SCOREBOARD OUTPUTS) – These are ¼" stereo
jacks used to connect directly to fixed-digit scoreboards,
clocks, and stat displays. J1, J2, and J3 all send out the
same scoreboard control signal.
For wireless systems, these jacks may not be needed. If the
console is equipped with a radio antenna, ensure that it
is pointed straight up during operation for best results.
 J4 (MAIN CLOCK START/STOP/HORN SWITCH) – This jack is
used for a main clock handheld start/stop switch. J4 may also be used
for external Precision Time console (for basketball).
 J5 (COMPUTER PORT) – Not used on this model
 J6 (I/O PORT) – This jack is the main input and output port. J6 is used
to send data to multiple displays (Scoreboard, Play Clock, and Locker
Room Clocks), communicate with other All Sport consoles, and send
Real-Time Data (RTD) to Daktronics display controllers.
 J7 (PLAY CLOCK START/STOP/RESET SWITCH) – This jack is
used for a play clock handheld start/stop/reset switch.
 J8 (SWITCH INPUTS) – Not used on this model
 S1 (POWER) – This switch is used to power the console ON and OFF.
Important Safeguards
1. Do not drop the control console or allow it to get wet.
2. To avoid electrical shock, do not disassemble the control
equipment or electronic controls of the display; failure to follow
this safeguard will also make the warranty null and void.
3. Always turn off and/or unplug the control equipment when it is
not in use. Never yank the power cord to pull the plug from the
outlet. Grasp the plug and pull to disconnect.
4. Do not let any power cord touch hot surfaces or hang over the
edge of a table that would damage or cut the cord.
5. If an extension cord is necessary, a three-pronged, polarized cord
should be used. Arrange the cord with care so that it will not be
tripped over or pulled out.
6. After receiving a new or replacement console, inspect for
shipping damage such as rattles and dents, and verify that
all equipment is included as itemized on the packing slip.
Immediately report any problems to Daktronics; save all
packing materials if exchange is necessary.