Daktronics All Sport 2000 Series - Manual (Page 43)

Team Name Operation
Note: Post, Esc and Message # are not used.
These operation instructions are for displays with team name message centers using a Venus
100 board. Section 14.7 covers team name message centers with current loop boards.
Each team name is entered as a separate message. Type in the first team name and press
<
ENTER >. The first team name is entered as message number one. Type the second team name
and press < ENTER > . The second team name is entered as message number two. The characters
for each name will appear on the left display as they are entered.
To post the name, press < POST >, which side (< LEFT > or < RIGHT >), the number of the message
and then . To get out of the post mode and return to the edit mode, press < ESC >
(which will also return the operator to message number one). Up to 99 messages can be saved.
Any of these messages can be displayed by pressing < POST >,< LEFT > or < RIGHT > , the message
number and < ENTER > . To scroll through the messages, from the edit mode press < ENTER > to
view the next message or < BACKSPACE > to review the previous message. To verify the
message number of the message being viewed on the LCD, press < MESSAGE# > and the message
number will be displayed on the left side of the scoreboard.
Note: If there are five messages in the console and a new message is entered while viewing
message four on the LCD, the original message four will be overwritten. Remember: The
message number will always go back to one every time the edit mode is entered.
Example: Enter SDSU in double stroke on the left side of the display and USD in single stroke
on the right side.
1. Press < DOUBLE
> and type in “SDSU”
2. Press < ENTER >
3. Press < SINGLE
> and type in “USD”
4. Press < ENTER >
5. Press < POST >, < LEFT >, < 1 >, <
ENTER
>
6. Press < POST >, < RIGHT >, < 2 >
,
< ENTER >
Press < EXIT > to leave the team name mode and change to the sport mode for timing and
scoring the game. After < EXIT >
is pressed, the console’s LCD will read “ENTER CODE.”
Enter the desired code.
Don’t forget to replace the team name overlay with the appropriate sport overlay.