Optional usb to ethernet configuration 3 of 3, Configuration without cd – Daktronics Optional USB to Ethernet Configuration User Manual

Page 3

Optional USB to Ethernet Configuration

3 of 3

DD1790707 Rev 2

12 September 2012

PO Box 5128 201 Daktronics Drive, Brookings, SD 57006-5128

tel: 800-325-8766 fax: 605-697-4700

www.daktronics.com

Windows XP

• Click

Yes, this time only and Next when the

Found New Hardware Wizard window opens.

• Click

Install the software automatically

(Recommended) and Next.

• Driver software installation starts automatically

9. Connect an Ethernet cable (not provided by

Daktronics) to the USB to Ethernet adapter.

10. Connect the other end of the Ethernet cable to the

communication device.

11. Wait until you see that new hardware has been

installed in the notification area in the lower-right
corner of your monitor before you click

OK.

12. Click Finish when installation is complete.

Configuration Without CD

1. After plugging the Ethernet Adapter in an open

USB port on the control computer, go to:

2. Click venus1500 > utils > USBEthernet > Driver >

install.html.

3. Click the Image of the device you are installing.
4. Click Save as and Save the file to your computer’s

hard drive.

5. Browse to the file and double-click DlinkSetup to

start the

Installation Wizard.

6. Click Next when the InstallShield Wizard opens.
7. Select I accept the terms in the license agreement

and click

Next.