Daktronics Ethernet Communication - Manual (Page 11)

Installation 5
1. Route the Ethernet cable through conduit to the back of the display. Use one of the
1 /
2
" conduit etched drill guides for access, being careful not to damage any internal
components. Use silicone and the conduit to seal the hole so water will not leak into
the display.
Remove all metal shavings from the cabinet after drilling.
2. Connect the Ethernet cable from the local network switch to the J1 input on the surge
card.
3. Signal connects from the J2 output on the surge card to the J4 (Galaxy) Ethernet input
on the controller, using the RJ45 cable attached internally to the signal input board.
4. Refer to Figure 3, Figure 4, and Figure 5 for examples.
Figure 3: Internal Components
Figure 4: Alternate Device Location
Figure 5: Alternate Signal Connections Galaxy