Daktronics TI-2025 Segment Timer - Manual (Page 11)

Mechanical & Electrical Installation 5
Section 3: Mechanical & Electrical Installation
Reference Drawings:
System Riser; TI-2025 Segment Timer .................................................. Drawing A-274283
3.1 Mechanical Installation
The scoreboards in this manual are portable and are equipped with a handle on the top for
easy transport.
Note: The handles are designed for carrying only and are not to be used as a temporary
hanger or for permanent mounting.
3.2 Power & Signal
The displays receive power through a 120 V AC power cord. The power cord plugs into a
standard three-pronged outlet. Flip the switch on the side of the display to power it on. The
display will remain blank until it receives signal from a controller.
Signal is provided in one of two ways: 1) via a 9-pin serial to 4-pin XLR cable (Daktronics part
number 0A-1196-0095) connected to the J31 signal input on the side of the display from the
top of the All Sport 100 console or 2) via radio transmission from the RC-50 controller to the
built in antenna. Refer to Drawing A-274283.
Note: Before using the RC-50, the All Sport 100 must first be connected to the timer in
order to set the practice values as described in the All Sport 100 Control Console
Operations Manual (ED-13432). Then the RC-50 can be used to run the practice from
anywhere on the field without being constrained by control cable.
Extension XLR cables are available from Daktronics.