Cybex 16180 Free Weight Leg Raise Chair - Manual (Page 9)

9
Cybex Owner’s Manual
• Area is not in the vicinity of high humidity, such as in the vicinity of a steam room, sauna, indoor
pool or outdoors. This unit is designed to function normally in an environment with a relative
humidity range of 30% to 75%.
Exposure to extensive water vapor, chlorine and/or bromine could adversely affect the electronics as
well as other parts of the unit.
• Area maintains an ambient temperature range of 50° F (10° C) to 104° F (40° C) degrees.
Tools Required
• Rubber mallet
• Flat head screwdriver
Assembly Procedure
Two people will be required for this procedure.
Plastic shipping foot glides are used on Cybex Strength Systems machines to protect the bottom of
machines during transportation. These foot glides must be removed before a machine is first placed
in service as the shipping foot glides may cause the machine to be unstable.
CAUTION: Remove glides
To avoid serious injury or property damage, remove foot glides before placing unit in
service. If guides are not removed unit will not be stable.
REMOVE FOOT GLIDES
1. Raise the foot of the machine slightly off the floor remove foot glides. Do not install weight stack (if
applicable) until all foot glides have been removed.
2. Loosen each foot glide by striking foot glide with rubber mallet.
3. Pry off foot guide using a flat blade screwdriver.
4. Place rubber feet (supplied with machine) on each foot of the frame.
Securely anchor machine to the floor
Cybex requires that equipment
MUST be secured to a solid level surface to maximize stability.
WARNING: Anchoring equipment:
• Cybex is not responsible for the actual anchoring of equipment. Consult with a
professional contractor.
• Use fasteners having a minimum of 500 lbs. tensile capacity (3/8’’ grade 2 bolts or
better).
• If legs/frame does not contact surface, DO NOT pull down with anchors. Shim
any leg or frame not in contact with surface using flat washers.