Dynex DX-MP3MT - Manual

1 Insert the swivel head into the swivel
head slot on the back of the holder and
slide it into place until it is secure.
2 Remove the thumbscrew on the bike
mount and set it aside.
3 Adjust the handlebar clamp to a
size that best fi ts your bike frame or
handlebars, then insert and securely
tighten the thumbscrew removed
earlier.
4 Loosen the adjustment or swivel head
knobs to adjust the viewing angle, then
retighten.
Package contents
• Bike mount
• Car mount
• Holder
• Quick Setup Guide
Caution: Do not adjust your Dynex bike
and car mount while riding a bike or
driving a car.
Features
Your Dynex bike and car mount securely
holds most MP3 players or smart phones
to your bike frame, handlebars, or car
window. Make sure that your electronic
device is securely fastened to the mount
before you begin your trip.
Caution: This mount is not intended for
extreme off -road use. Excessive bumping
and jarring may result in damage to your
device.
DX-MP3MT
Bicycle and car mount for MP3 devices
Holder (closed)
Holder (open)
Attaching an MP3 device to
the holder
1 Repeatedly press the release button
on the side of the holder. The clamps
open.
2 Unfold the feet on the bottom of the
holder.
3 Adjust the clamps to fi t the height of
your device.
4 Insert your device on the holder and
close the clamps by squeezing them
together tightly until your device is
secure.
Attaching to a bike
Bike mount
Clamps
Feet
Release
button
Swivel
head slot
QUICK SETUP GUIDE
Handlebar
clamp
360° swivel
head
Adjustment
knob
Thumbscrew
Swivel head
knob
DX-MP3MT_11-0296_QSG_V1_EN.indd 1 DX-MP3MT_11-0296_QSG_V1_EN.indd 1 3/21/2011 2:09:45 PM 3/21/2011 2:09:45 PM