The ip addr tab, Ip a, 11mbps wireless access point user's manual – ConnectGear WA300 User Manual

Page 25

Text mode
Original mode

11Mbps Wireless Access Point User's Manual

The IP Addr Tab

IP ADDR: displays the status of current IP setting .

IP Address Mode: Select “Static” or “DHCP” mode. For “Static” mode, the IP

address settings are given by user. For “DHCP” mode, these
settings will be overridden by a DHCP server on your network.
The default setting is “Static”

IP Address: The static IP address you want to assign to the AP. The default value

is “192.168.1.100”.

IP Subnet: The subnet mask you want to assign for the AP. The default value is

“255.255.255.0”.

IP Gateway: The gateway you want to assign for the AP. The default value is

“192.168.1.1”.

Allow upgrade uploads: Check the box, and then it is allowed to upgrade

firmware.

Note!

You may need to re-load the page to see any new settings.