ConnectGear GA-H03D - Manual (Page 5)

3. Installation
This chapter describes how to install your CardBus Card.
(1) Hardware Installation
Hold the Card label up and insert the card into the notebook
PCMCIA/CardBus slot with 68 pin connector facing the
notebook.
(2) Software Installation
The drivers and utilities are supplied by the CD-ROM included
in this product. For detail description. Please refer to document
in the CD-ROM provides by this product.
4. Trouble Shooting
If you experience any problems with the PC Card, first make
sure the appropriate driver is loaded, the proper cable is
connected to the PC Card and the hub complies with the
adapter specification, then check the LED.
The PC Card provides two LEDs to indicate network status.
(1) 10M
This LED indicates the connection speed in 10Mbps. When
the light is on, it indicates that the 10Mbps connection is
established. When the light is blink, it indicates that the
packets are transmission.
(2) 100M
This LED indicates the connection speed in 100Mbps. When
the light is on, it indicates that the 100Mbps connection is
established. When the light is blink, it indicates that the
packets are transmission.