Compuprint 4247-L03 Safety Information - Manual (Page 118)

installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense. Properly shielded and grounded
cables and connectors must be used in order to meet FCC emission limits. Compuprint is
not responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorized changes or modifications to
this equipment. Unauthorized changes or modifications could void the user’s authority
to operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
European Union (EU) Conformity Statement
Compuprint srl declares that this product is in compliance with the essential requirements
and other relevant provisions of Directive 2006/95/EC, 2004/108/EC.
Per the applicable requirements of EU directive 98/37/EC (“machines”) sound pressure of
the above product (measured according to EN27779) does not exceed 70dBA.
This product has been tested and found to comply with the limits for Class A Information
Technology Equipment according to European standard EN 55022. The limits for Class A
equipment were derived for commercial and industrial environments to provide reasonable
protection against interference with licensed communication devices. Important This is a
Class A product. In a
domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.
Properly shielded and grounded cables and connectors must be used in order to reduce the
potential for causing
interference to radio and TV communications and to other electrical or electronic
equipment. Compuprint srl cannot accept responsibility for any interference
caused by using other than recommended cables and connectors.
Industry Canada Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conform à la norme NMB-003 du Canada.
11 4 Safety Information