Coloronix SCC5-RM - Manual (Page 3)

Using SCC5-RM ColorRay Remote Control
Using SCC5-IR
1. Connect IR cable to data enabler “DATA IN” port.
2. Set master data enabler to dip switch 9, 10 in the “ON” position.
3. Pull battery tab
4. Point remote control to receiver and push desired button to activate lighting
(See page 4 for button assignment)
Note: Does not require separate power supply.
Using SCC5-IR-DMX
1. Connect IR cable to data enabler “DATA IN” port.
2. Set all data enablers to dip switch 1 in the “ON” position
3. Pull battery tab
4. Point remote control to receiver and push desired button to activate lighting
(See page 4 for button assignment)
Make sure to connect 120VAC power to IR receivers
Page of 4 – Coloronix SCC5-RM ColorRay Remote Control Manual V.1.0
3