CHIAYO UDR-1000 - Manual (Page 7)

5. To adjust the Volume of the system
The ▲ and ▼ buttons at the front panels serve as the Volume Controls of the
receiver. It can be pressed at any moment. Whenever it is pressed, the following
display will appear :
The first line of the display remains the same as whichever status when the button is
pressed. Only the second line of the display will show the word VOL and the digit in
the bracket is the current status of the volume level. The bar is just the graphical
representation of the level. Pressing the ▲ button will increase the digit as well as
the bar. Pressing the ▼ button will decrease the digit as well as the bar.
A←CH : 01 - 01→B
Vol 6
After entered user mode
Press SET button for 2 seconds to enter the SET mode and the cursor will flash.
Use the ▲ or ▼ button to select the digit desired. The two digits at the top right
corner is Channel.There are 40 channels for user to make frequency setting. After
selecting any channel, press SET and the cursor will move to the first frequency
digit, indicating to start setting its corresponding frequency. Please note that all
frequencies MUST be within the bandwidth or setting will be invalid. If all finished,
press SET for about 3 seconds to save changes to User Mode.
USER EDIT : 01
800.000 MHz
USER EDIT : 01
800.000 MHz
Beltpack Transmitter : UB-2000 (UHF)
8
10
11
Antenna
Battery weak / audio mute indicator
Audio mute switch
Mini-XLR connector
Power ON / OFF switch
LCD display
Mini USB port
Cover release button
Charging contacts
Lavalier microphone
Mic clip
12
13 14
16 15
14
13
12 SET
UP
DOWN
GT
MT
15
16 9
GAIN setting (GT/MT)
Gain control is an adjustable design that enables user to set different output levels. GT is for
the use of instrument with high impedance, such as guitar while MT is for the use of low
impedance such as lavalier or headset microphone.
9 6