Dodge 2008 DX-49 Magnum SRT8 - Manual (Page 148)

NOTE: After training a HomeLink
௡ channel, if the
garage door does not operate with HomeLink
௡ and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading “Programming A Rolling Code System.”
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “learn” or “training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).
6. Firmly press and release the “learn” or “training”
button. The name and color of the button may vary by
manufacturer.
1 — Garage Door Opener
2 — Training Button
146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE