DeLonghi TRF1 15 - Manual (Page 3)

3
TRF1 15
3
Thank you for choosing this De’Longhi radiator. To get the
very best out of your new radiator it is advisable to read these
instructions before using it.This will ensure that you gain opti-
mum results and use the appliance safely.
General instructions
Take the radiator out of its packing box and remove any polystyrene pie-
ces or any other packaging material that might be lodged inside it.
Make sure that the radiator has not been damaged during transit and
that the mains cable is in working order. Do not operate the radiator if
damaged.
Fitting the feet
Remove the feet and the wheels from the polystyrene packing.
Turn the radiator upside-down on a rug or a soft surface in order to
prevent damaging the paint finish.
Fit the wheels to the spindles and push firmly until they click into posi-
tion, then insert the foot in it seat and push it till it hooks into position
(see fig.1).
Electrical connection
- Before plugging the radiator into the mains, check that your supply
voltage is the same as that shown on the rating plate of the radia-
tor.
- If using more than one appliance at a time, it is important to ensure
that the ring main is adequate to cope with the power require-
ments.
- It is important to ensure that the socket is adequately earthed.
- This radiator complies with EEC Directive 89/336 relating to elec-
tromagnetic compatibility.
How to use it
Switching on
Plug the radiator in; position the thermostat slider to the maximum
position (6); turn the appliance on by pushing the foot switch as follows:
With appliance off:
Press the foot switch once: only radiator on (the left side indicator
light will switch on ( ).
Press the foot switch twice: only fan heater on (the right side indi-
cator light will switch on ( ).
Press the foot switch three times: the combined function radiator
+ fan heater will be on.
Press the foot switch four times: the appliance will switch off.