Features + settings – DLO TransDock Classic User Manual

Page 6

| 11

10 |

DLO TRANSPOD USER MANUAL

Features + Settings

Setting Preset Stations

Follow these simple steps to set your own preset stations:

1. Using the

Tuning Buttons

, tune TransDock Classic to the station that you’d

like to save as a preset.

2. Press and hold the

Preset Button

on the right side of TransDock Classic for

a few seconds to save that station as a preset channel. The display on

TransDock Classic will flash the preset channel you just set (e.g.,

CHO1

3. Press the

Preset Button

to cycle to the next preset channel. Repeat steps

1 and 2 for all available preset channels (up to four).

E::

Your new preset will override whatever preset was last saved on that

channel.

Controlling the LCD Backlight

TransDock Classic features an indigo blue backlit LCD display. The backlight

comes on automatically when you power up TransDock Classic, and any time you

change frequencies. The backlight automatically turns off after two minutes.

You can also manually operate the backlight by pressing the

Backlight Button

the left side of TransDock Classic. If the backlight is already on, pressing this

button will immediately turn it off. If the backlight is off, pressing this button will

turn the backlight on indefinitely. To turn it off, press the

Backlight Button

again.

TransDock Classic Intelligent Power Control

TransDock Classic features Intelligent Power Control, meaning TransDock Classic

turns on automatically when you plug it in or when you connect your iPod, and

automatically shuts off when not in use for two minutes. This feature is ideal for

cars whose auto power outlet continues to draw power, even when the car is off.

TransDock Classic will turn itself off – protecting your car’s battery.

E::

TransDock Classic will not turn off as long as a player or device is attached.

To manually power down TransDock Classic, hold the

Backlight Button

down for

several seconds. This will completely turn off TransDock Classic until you manual-

ly turn it on again or it automatically turns on as described above. To manually

turn TransDock Classic back on, press and hold the

Backlight Button

for three

seconds.

Getting the Best Sound Quality

• Make sure the frequency you’ve tuned to is empty. A good place to start is 88.5,

which is the initial frequency on TransDock Classic and is often an open fre-

quency. Visit

www.dlo.com/openfm

to search for the best frequencies in your

area.

• TransDock Classic will tune to any radio frequency from 88.1 to 107.9, so try the

entire spectrum until you find an unoccupied frequency. To learn more, please

read

Finding Empty Radio Frequencies [pg 8]

• Be sure to manage the volume, bass and treble settings of your iPod music

using your car stereo’s controls.