Caple C621 - Manual (Page 15)

Page 15
C621 C721 user manual.DOC
On gas valves provided with adjustment screw on
the valve body (fig. 7.6):
• Turn the screw "A" to the correct setting with a
screwdriver.
For G 30/G 31 gas, tighten the adjustment screw
completely.
LUBRICATING THE GAS TAPS
If one of the gas taps becomes difficult to turn, dismantle it, thoroughly clean with petrol
and apply special high-temperature grease.
These operations must be performed by a specialist engineer.
----------------------------------------------------------------------------------------------------------------
ELECTRICAL SECTION
IMPORTANT: Installation has to be carried out according to the instructions
provided by the manufacturer. Incorrect installation might cause harm and
damage to people, animals or objects, for which the manufacturer accepts no
responsibility.
DETAILS
• Connection to the electric power supply must be carried out by a qualified technician and
following the appropriate safety regulations;
• Before carrying out the connection to the power supply, the voltage rating of the
appliance (stamped on the appliance identification plate) must be checked for
correspondence to the available mains supply voltage, and the mains electric wiring
should be capable of handling the cooker's power rating (also indicated on the
identification plate);
• The appliance is supplied without a power supply plug and therefore if you are not
connecting directly to the mains, a standardized plug suitable for the load must be fitted.
• The power point must be connected to a suitable earth wiring, in conformity to current
safety regulations.
• The colours of the wires in the hob power cable may not correspond with the colours
marked on the terminals of your electrical plug. The plug should in any case be wired as
follows: -
o Connect the green/yellow wire to the terminal marked with the letter E or the
earth symbol or coloured green/yellow;
o Connect the blue wire to the terminal marked with the letter N or coloured
black;
o Connect the brown wire to the terminal marked with the letter L or coloured
red.
• It is possible to connect the appliance directly to the mains supply by means of a heavy-
duty switch with 3 mm minimum distance between the contacts.