Caple C2214 User Manual
Page 12
12
flat surface, there must be an aperture of at least 45x560mm.
45mm
56
0m
m
The panels of the adjacent cabinets must be made of heat resistant material. In particular, cabinets
with a veneer exterior must be assembled with glues which can withstand temperature of up to
100℃
In compliance with current safety standards, contact with the electrical parts of the oven must not
be possible once it has been installed.
All parts which ensure the safe operation of the appliance must be removable only with the aid of a
tool.
For the correct centring of your appliance, position the 4 tabs on the sides of the oven in
correspondence with 4 holes on the perimeter of the frame. In particular, if the cabinet side panel：
1 is 20mm thick: removable part of the tab must be removed (Fig A);
2 is 18mm thick: use the first groove, which is factory-set (Fig B)
3 is 16mm thick: use the second groove (Fig.)