Dixon 6000 Series - Manual (Page 11)

Page 11
CHASSIS: Sheet metal construction frame
BODY: Folded sheet metal. Seat lifts up for access to battery and belt service.
SEAT: Designed for operator comfort by use of high density closed cell foam
padded back and arm rests, upholstered with Cordura TM water-repellent
fabric. Seat is adjustable fore and aft.
MOWER DECK: 2 Decks are available. 60" & 48" are made of 12 GA fabricated welded
construction with 10 GA reinforcement plate. 3 blades combine for either
a 48" or 60" cut width. Cut height approximately 1" to 5" via 9 position
lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission. The hydrostatic transmissions, in
turn, power a fully enclosed HydroGear gearbox.
ENGINE: 25HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve,
Air-Cooled, Gasoline, Horizontal Shaft, Aluminum Head, and Crankcase
with Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-
type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition,
In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
TIRES: Front 4.10x3.50x4
Rear 5.00-6x13
Drive 20-10.0x10
RECOMMENDED Front 16 lbs.
TIRE PRESSURE: Rear 12 lbs.
CAPACITIES: Fuel - 5 gallons
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 25
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS: Width 57-1/2”(48" Deck), 69-1/2"(60" Deck)
Height 45-1/2"
Length 96" (48” Deck), 101” (60” Deck)
Weight 960 lbs. (48" Deck), 1030 lbs. (60" Deck)
NOTE: Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
SPECIFICATIONS
6000 Series Forward Mount