Caple C232SS - Manual (Page 13)

13
A
U
T
O
P
A
U
T
O
P
Fig. 3.6 Fig. 3.5
AUTOMATIC OVEN COOKING
To cook food automatically in the oven,
it is necessary to:
1. Set the length of the cooking period
2. Set the end of the cooking time
3. Set the temperature and the oven
cooking program.
These operations are done in the
following way:
1. Set the length of the cooking period
by pushing the button and the
( ) button to increase, or ( )
to decrease if you have passed the
desired time (fig. 3.5). The AUTO and
the
symbol will illuminate.
2. Set the end of the cooking time by
pressing the button (the cooking
time already added to the clock time
will appear), and the
( ) button
(fig. 2.6); if you pass the desired time
you may get back by pushing the
(
) button.
After this setting, the symbol will
disappear. If after this setting, the
AUTO flashes on the display and a
buzzer sounds, it means there was
an error in the programming, that is
that the cooking cycle has been
superimposed on the clock. In this
case, modify the end of cooking time
or the cooking period itself by follow-
ing again the above mentioned
instructions.
3. Set the temperature and the cooking
program by using the switch and ther-
mostat knobs of the oven (see specific
chapters).
Now the oven is programmed and every-
thing will work automatically, that is the
oven will turn on at the right moment to
end the cooking at the established hour.
During cooking, the
symbol remains
illuminated.
By pushing the
button you can see
the time that remains until the end of
cooking.
The cooking program may be can-
celled at any time by pushing
.
At the end of the cooking time the oven
will turn off automatically, the
symbol
will turn off, AUTO will flash and a buz-
zer will be sound, which can be turned
off by pushing any of the buttons except
the
( ) / ( ) buttons.
Turn the switch and thermostat knobs to
zero and put the programmer onto “man-
ual” by pressing the
button.
Attention: After a power cut the clock
resets to zero and cancels the set pro-
grams.
After a power cut, three zeros will flash
on the display.