Caple WMF1020 - Manual (Page 19)

46
On display models, when the programme is
running you can see which phase it is at on the
display, as well as how long there is to the end
of the programme. On non-display models the
phase the programme is at is shown by the
LEDs.
The active phases will appear successively at
the top of the display as the programme
progresses. The time remaining until the end of
the programme will also appear on the display.
It updates at regular intervals, but not minute by
minute.
Any option button can be selected provided the
wash phase in which it takes effect has not been
passed and when the programme accepts the
option.
Pressing the delay button during the wash has
no effect on the washing machine.
Pressing the start/pause button during the wash
activates the PAUSE function.
8 WASH PROGRAMME PHASES AND POWER CUTS
using the appliance
PROGRAMME
PHASES
If there is a power cut, when the electricity
comes back on the washing machine will
continue to run from where it left off (it has
several hours of memory). The same will happen
if the ON/OFF button is pressed.
POWER CUTS
warnings
Level the washing machine by adjusting the
feet to reduce the noise caused by spin-drying.
Try and wash clothes of different sizes in the
same wash programme to favour the distribution
of the clothes inside the drum during spin-drying.
All the models have a safety system for spin-
drying that prevents spin-drying from being carried
out if the distribution of the clothes inside the
drum is too concentrated. This prevents the
appliance from vibrating too much.
If you find that the clothes are not properly wrung
out, try spin-drying them again after having
distributed the clothes more evenly in the drum.
Important
If you change the wash programme during
the wash using the selector, the PAUSE
function is activated and the programme is
cancelled.
If you need to add or remove a garment,
press the start/pause button and make sure
that the water level is not above the door
overflow level and that the temperature
inside is not high. Press the start/pause
button again to restart the wash from the
same cycle phase it had stopped at.