Caple WF332 - Manual (Page 8)

7
Troubleshooting
Try the suggestions below to see if you can solve the problem before calling the service engineer.
PROBLEM POSSIBLE CAUSE
The wine cabinet does not operate. The appliance is not plugged in.
The appliance is turned off.
The circuit breaker has tripped or a fuse has
blown.
The wine cabinet is not cold enough. Check the temperature control setting.
During hot weather a higher setting is
needed.
The door has been opened too often.
The door is not closed completely.
The door gasket does not seal properly.
There is insufficient empty space around the
cabinet.
The wine cabinet turns on and off frequently. The room temperature is hotter than normal.
A large amount of un-cooled wine has been
added.
The door has been opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
There is insufficient empty space around the
cabinet
The wine cabinet vibrates. Check that the wine cabinet is level.
The wine cabinet seems to make too much
noise.
The slight rattling noise may come from the
flow of refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The wine cabinet is not level.
The door will not close properly. The wine cabinet is not level.
The door was reversed and not properly
installed.
The gasket is dirty.
The shelves are out of position.
For technical advice or product service please call the Caple helpline on:
0844 800 3830