Caple WC6216 - Manual (Page 5)

5
Setting The Temperature Controls
•
The temperature setting range as below:
Upper compartment: 5
～10ºC
Lower compartment: 10 ～18ºC
•
The factory set temperature is as below:
Upper compartment: 6 ºC
Lower compartment: 12ºC
•
When the system enters the temperature set up. Each press on the button,
the temperature setting of the upper zone will increase by 1 ºC, When the temperature setting
reaches the upper limit of 10ºC, the temperature will return to 5ºC. Each press on the and
temperature setting of the lower zone will lower by 1ºC ,When the temperature setting
reaches the upper limit 18ºC, the temperature will return to 10ºC.
•
If you wish to view the actual temperature inside the wine cabinet. Please press the
or button and hold for 3 seconds. The actual temperature of the upper zone or the lower
zone will be displayed on the control board. After 5 seconds the temperature will return to
display the setting temperature.
•
Flashing word= Actual Temperature
Steady word = Set Temperature
Note:
• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine cabinet will not
start.
• When you use the Wine cabinet for the first time or restart the Wine cabinet after having been
shut off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the LCD readout. This is normal and it is due to the length of
the activation time. Once the Wine cabinet is running for a few hours everything will be back to
normal.
Function Instruction
•
Temperature Memory Function
In the event of a power interruption, wine cabinet will remember the previous temperature
settings and when the power is recovered, the cabinet temperature will go back the same
setting temperature as power off.
•
Open Door Alarm
When you forget close the door or the door is not closed completely, the alarm will sound after
5 minutes. Please close the door completely to avoid cold energy being lost.
•
Temperature Alarm
If inner temperature is higher than 23°C, “HI” is shown in display panel, the alarm will sound
after one hour continuously. It inform that the inner temperature is too high, please check the
reason.
If inner temperature is lower than 0°C, “LO” is shown in display panel the alarm will
sound in addition the malfunction indicator will light at the same time.