Caple MOT900 - Manual (Page 6)

6
MOT900 MODEL ONLY
Perform the electric connection, activate the
glass panel lifting up, as shown in the ‘Wor-
king’ section; when the panel is completely
open, which is done by setting the IV spe-
ed, remove the grid as shown in (fig. 6), then
remove the grease filters and make sure the
hood is securely fixed to the wall, by using
the inside screws (fig. 7).
Reinsert the grease filters, the grid and close
the front panel by setting the OFF function, as
shown in the ‘Working’ section.
Remove the lower light panel fixing screws
(fig. 8), rotate the light panel (fig. 9) and fix
the appliance to the wall with the screws pro-
vided, as per (fig. 10).
Reinsert the light panel.
LUC600 MODEL ONLY
Adjust the position of the hood horizontally
and vertically by acting on its screws through
its top hole, as per (fig. 11).
Remove the grease filter, held up by magnets,
by pulling it downwards (fig. 12).
Remove the front light panel (white), also held
up by magnets, by pulling it outwards (fig.
12), then disconnect the bipolar electric con-
nector. Insert the screw anchors and screws
provided in the holes indicated by the arrows
(fig. 13).
If the appliance is installed in the sucking
version, remove the grid covering the motor
air out-let (fig. 14).
Reinsert the grease filter and the light front
panel, making sure the electric connector is
connected properly.
* Sucking version
Fix the pipe bearing bracket to the wall and/
or ceiling by using the anchor screws and
screws provided (fig. 15), centred to the
hood.
Connect the motor air-outlet flange to the
exhaust hole, by using a suitable pipe. Per-
form the electric connection. Place the two
ornamental pipes on the hood body ; lift the
internal pipe up until it reaches the ceiling;
then fix it to the pipe bearing bracket, by
using the two self-threaded screws provided.
INSTALLATION
*Before installing the appliance, make sure
that none of the parts is damaged in any
way.
In case of damaged parts, contact your retai-
ler and do not proceed with installation.
Read all of the following instructions carefully
before installing the appliance:
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe elbows.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in the pipe sec-
tion (recommended constant diameter: Ø 150
mm or equal surface area).
-The manufacturer shall not respond for air
capacity or noise problems due to non- com-
pliance with above mentioned instructions,
and no warranty shall be given.
The model MOT900 has been designed in
order to have the possibility of directing the
air out-let in the rear side of the appliance; if
you chooe to use this function, it is necessary
to remove the no. 10 screws of the sucking
unit support (fig. 3), take out the sucking
unit and rotate it in such a way to direct the
air out-let nozzle towards the rear side of the
appliance (fig. 4); then place the sucking unit
in its seat again and tighten the screws pre-
viously removed.
By using its drilling template (fig. 5A), drill
the holes for the wall bracket installation; The
model MOT900 shall be installed at a mini-
mum distance of 400mm from the cook-top.
Assure a distance of 650mm from the cook-
top with LUC600 model.
Fix the brackets to the wall, by using the
screw anchors and screws supplied with the
product;
Hang the body to the wall brackets previously
fixed.