Caple DD900 - Manual (Page 9)

9
Model SDD2 TOUCH CONTROL VERSION (Fig. 15)
OFF switch: (Fig. 15) It is used to close the aspiration panel completely or to position it at inter-
mediate heights at least mm 180 above the cooktop. While closing the aspiration panel keeps
on working at the speed set up to the height of mm 180 from the cooktop. Below this height
the aspiration function is automatically cut out.
On switch/+: (Fig. 15) It is used to extract the aspiration panel up to the maximum height of
mm. 300 and to set automatically the first aspiration speed when reaching the height of mm
180 from the cooktop.
When pressing the button again after reaching this height, the aspiration motor speed can be
increased.
If the aspiration panel is positioned at an intermediate height between mm 180 and mm 300,
the aspiration panel can start raising again by pressing first the OFF switch and then the On/+.
Switch.
Leds: (Fig. 15) The different speed levels are indicated by blue leds (1. Speed level corresponds
to the led down on the left).
MINUS SWITCH: (Dis. 15) it is working only if the position reached by the aspiration panel
is higher than mm 180 from the cooktop. It is used to decrease the aspiration motor
speed.
TIMER SWITCH: (Fig. 15): it is used to stop automatically the aspiration system and to close the
timer once 10 minutes has expired.
Other functions:
- After 30 hours of appliance operation, the push button panel indicates saturation of the
grease filters by the buttons flashing. To reset, press the timer button.
- After 4 hours of continuous operation from the last setting, the appliance turns off and
closes automatically.
- When the front panel is removed for cleaning and maintenance operations, all the electronic
aspiration and movement functions are locked.
- Anti pinching safety device: if anything is obstructing the closure operation of the down-
draft, the operation will stop and the downdraft will move up again.
3/ HOW THE HOOD WORKS