Caple ST850SS - Manual (Page 5)

9
Essential precautions to respect before in-
stalling the appliance are the following:
To have made a cut-out on the bottom of the
cabinet which is suitable to hold the appliance
in position (fig.4 for S901, fig. 4A for S902).
- prepare the power supply.
- prepare a hole for the exhaust of the air
both in the filtering and in the exhauting ver-
sion.
To install the appliance, adjust the position
of the stop side-springs using the appropria-
te screws (fig.5), according to the thickness
of the board previously drilled, on which the
appliance will be fixed.
Insert the built-in unit in the hole made in the
cabinet until the stop click of the side- sprin-
gs is heard and the built-in unit is blocked.
Insert the screws provided in the holes inside
the appliance (fig.6) to block it completely.
Put the grease filter again
Blocking of the stop valve
Warning!
Before connecting the flexible exhausting
pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can
swing.
Exausting version
Connect the flange to the exhausting hole
with an appropriate pipe. Connect the ap-
pliance with the electrical mains through the
supply cord.
Filtering version
Connect the flange with a pipe suitable to
convey the air to the top of the cabinet. Con-
nect the appliance with the electrical mains
through the supply cord.
Mod. S901-S902 (fig. 10)
A: Light switch on/off
B: Motor switch on speed 1/off
C: Motor switch on speed 2
D: Motor switch on speed 3
E: Motor switch on speed 4
F: 10-minutes timer
WORKING
MAINTENANCE
- An accurate maintenance guarantees good
functioning and long-lasting performance.
- Particular care is due to the grease filter pa-
nel. It can be removed by pushing its special
handle toward the back-side of the cooker
hood and turning the filter downwards so to
unfasten it from its slot (Fig.3).
To insert the filter just perform the opposite
operation.
After 30 hours working, the push button
control panel will signal the saturation of the
grease filter by lighting all the buttons. Press
the timer button to reset .
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
- In case the appliance is used in its filtering
version, the active coal filter (Fig.7) needs to
be periodically replaced. The coal filter can
be removed by removing the grease filter
first (Fig.3), and by pulling its special plastic
tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the
opposite way.
The coal filter needs replacing depending
on the use, but however every six months at
least.
- How to remove the oil tank. After having
removed the grease filters and eventually the
active coal filters, please hold the oil tank up
by one hand and ioosen the three handles by
the other hand as showed in fig.8. Then let
the tank slide downwards making attention in
order to avoid the leak of oil.
- To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
- Warning! To take down the appliance from
the cabinet, remove the definitive fixing
screws (fig. 6) using a screw-driver, get off
the grease filters (fig.3) and the active carbon
filters, if they are inserted (fig. 7).