Caple 1MINCH7 - Manual (Page 5)

Installation
1. The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking
surface for the best effect. See Pic 3.
2. Install the cooker hood between two cupboards. Drill and screw on the side boards of the
cupboards (the holes≤2mm).The distance between the head of the screw and the side board
should be 5mm, and the distance between the screw and the cooking surface should no less
than 1040mm. If there is not enough room, you can place it higher or lower. See Pic 4
3. Hang the cooker hood on the screws between the two cupboards. See Pic 5
4. Push the fan-shaped door frames to the end, in order to make the outer edges of the door
frames at the same
vertical level as the outer edge of the cupboards. See Pic 6
5. Mark the positions where you install the lower screws. Drill the upper hole and fix the screws.
Make sure all four screws are well fixed. See Pic 6
6. Connect the air-outlet board and the air-outlet tube.
7. Door installation: The door should be no less than 16mm thick, 385-700mm high, and weigh
no more than 7KG. Pull out the movable fan-shaped door frames by the plastic handle, and
place the fan-shaped door frames one on left and one on right. See Pic 8
8. Mark the installation position of the door and the size of the fixed screws. If the upper edge of
the door is not as high as the upper edge of the cupboards, please adjust the size accordingly.
Mark the positions of the screws on the door, and make sure the size is as
accurate as 569±1. See
Pic 9
9. Fix the fan-shaped door frames on the door with screws. Make sure the frames are
symmetrical.
Install the door into the cooker hood, the two sides of the door can be pulled to the end and the door can be safely
locked. If the door can not be safely locked, you can release
the plastic handle. See Pic 10
10. The two screws on both sides of the cooker hood can adjust the sliding of the door, according
to the weight of the door. See Pic 11
11. Install the adjusting plate, in order to cover the gap between the wall and the bottom of the
cooker hood. See Pic 12