beautypg.com

Caple T80BUCHSS4 User Manual

Page 3

background image

J130

3

counterclockwise direction and remove the filter

from its seat (Fig. 2).

To install the new filter proceed as described above

in the reverse order.

Clean frequently au the deposits on the fan and

other surfaces, utilizing a cloth moistened by

methylated spirits or neutral and not abrasive fluid

detersive.

REPLACING HALOGEN LAMPS

- Unplug the appliance from the electrical power

supply;

- Unscrew the chrome-plated diffuser ring and

remove them;

- Replace the faulty lamps, using only 20 W (max)

halogen lamps;

- Remount the chrome-plated diffuser rings.

REPLACING INCANDESCENT LAMPS

40W (E14) max

- Disconnect the hood from the electricity

- Remove the grate

- Replace the damaged lamp with one of the

same power.

WARNING! UNDER CERTAIN CIRCUMSTANCES

DOMESTIC APPLIANCES MAY BE DANGEROUS.

- Do not check filters with hood running.

- Do not obstruct vented outlets.

- Do not touch light bulbs or lamp-cover after long

periods of use.

- Not to be used over eye-level grill.

- No food must be cooked flambè underneath the

hood.

- The use of an unprotected flame is dangerous

for the filters and could cause fires.

- When frying foods, never leave the pan alone,

because the cooking oil could flare up.

- Before performing any maintenance operation,

disconnect the hood from the mains.

- The manufactures refuse to accept any

responsability for eventual damages to the hood,

because of failure to observe the above

instructions.

MAINTENANCE

The effective functioning of the hood depends on

the regularity with which the maintenance

operations are carried out, particulary in the case

of the synthetic-fibre and activated charcoal filters.

Grease filter

It has the function of catching the fat and solid

particles suspended in the air. It is thus subject to

clogging at various intervals, according to use and

the type of cooking.

In any case it is necessary to clean the filter at

least every two months, or replace it.

The grease filter is available in four versions:

acrylic, paper, metal and stretched aluminium.

The acrylic filter should be washed by hand in

warm water using a neutral liquid detergent.

Let soak and allow the grease and impurities to

escape. Let dry without twisting.

The paper filter cannot be washed and must be

replaced when the red lines appear on the bottom

part of the filter. The lines are visible through the

holes in the grill.

The metal filter lasts almost indefinitely. The

cleaning procedure is the same as that for the

acrylic filter. Let dry before reinstalling.

Stretched aluminium filters they are to be

washed by hand or by dishwashev once a month

and leaving them to dry before fitting.

Failure to correctly follow these cleaning

procedures will result in the risk of fire.

Charcoal filter

The charcoal filter, present only in the filtering

version, has the function of trapping odors and

purifying the air.

The saturation of the charcoal filter occurs after

more or less prolonged utilization, depending on

the type of cooking and on the regularity of

cleaning of the grease filter. In any case it is

necessary to replace the cartridge at least every

four months.

TO REMOVE THE CHARCOAL FILTER,

PROCEED AS FOLLOWS:

- Remove the frame

- Turn the center knob on the charcoal filter in the

This manual is related to the following products: