Caple SLF4 - Manual (Page 6)

Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out in
this manual. All responsibility, for any eventual inconveniences,
damages or fires caused by not complying with the instructions
in this manual,is declined.
Installation
The cooker hood must be placed at a minimum distance of 65
cm from the cooking plane for electric cookers and 75cm for
gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue ( Suction Version A - exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version F:
the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.
Electrical connection
The electrical tension must correspond to the tension noted on
the label placed inside the cooker hood. Connect the electrical
plug, where provided, to the an easily accessible outlet in
conformity with local standards in force.
Where an electrical plug is not provided (for direct connection
to electrical network) place a standards approved bipolar
switch with an aperture distance of not less than 3mm
(accessible) from the contacts.
Functioning
INSTRUCTION ON MOUNTING AND USE
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
Cleaning:
The cooker hood should be cleaned regularly internally and
externally.
For cleaning use a cloth moistened with denatured alcohol or
neutral liquid detergents.Avoid abrasive detergents.
Warning:Failure to carry out the basic standards of the
cleaning of the cooker hood and replacement of the filters may
cause fire risks. Therefore we recommend observing these
instructions.
Anti-grease Filter:
must be cleaned once a month, with non abrasive detergents,
by hand or in dishwasher on low temperature and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter (only for filter version):
The active charcoal filters F are not washable nor regenerative.
It should be changed every 6 months in normal use.
The active charcoal filters capture unpleasant cooking odours.
Replacing lightbulbs:
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Extract the lamp cover by levering it off with a small
screwdriver or similar tool.
Replace the damaged light bulb.
Close the lamp cover (it will snap shut).
Fastening of shelves (optional):
GB
A. Lights ON/OFF
B. Motor speed OFF
1 – 2 – 3. Adjustment hood speed: minimum (1), average (2),
maximum (3)
In the case of an excessive concentration of steam, adjust
the hood to maximum speed. We advise starting the hood
five minutes before beginning to cook and continue the function
for at least 15 minutes after having finished cooking.
Maintenance
A B 1 2 3
A B 1 2 3
GB
3
Fasten the four side supports (I) to the adjacent cabinets and
place the shelf on the supports.