Caple F Series Chimney - Manual (Page 3)

Page 3 of 7
F SERIES CHIMNEYS
Hood Description - Fig. 1
1. Control panel
2. Metal grease filter
3. Worktop illumination
Use: Two systems are available
Exhaust mode (Fig: S)
Vapors are extracted outside through an exhausting pipe that is
affixed to the connection ring above the hood.
Diameter of the exhausting pipe must be equal to that of the
connection ring.
In the horizontal runs the duct must be slightly slanted (about
10°) and directed upwards to vent the air easily from the room to
the outside.
Attention!
If the hood is supplied with carbon filter then it must be
removed.
Filter mode (Fig: K)
This version is used when there is no exhaust duct for
venting outdoors or when it is impossible to install one.
The air is filtered through a carbon filter (for its installation
see paragraph "Carbon filter") and re-circulated into the
room through the grating on the lower side of the
chimney.
Attention!
If the hood is not supplied with carbon filter, then it must be ordered and
mounted.