Campomatic WM950XE - Manual (Page 19)

19
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge
of a sink using the
plastic hose guide
supplied with the
machine.
In this case, make sure
the end cannot come
unhooked when the
machine is emptying.
This could be done by
tying it to the tap with a piece of string or attaching it
to the wall.
In a sink drain pipe branch.
This branch must be above the trap so that the bend
is at least 60 cm above the ground.
Directly into a drain pipe at a height of not less than
60 cm and not more than 90 cm. The end of the drain
hose must always be ventilated , i.e. the inside
diameter of the drain pipe must be larger than the
outside diameter of the drain hose.
The drain hose must not be kinked.
Screw tight the tap in the
direction of screw thread
of the inlet hose. Connect the hose to the water
inlet at the back of the washing
machine.
3 4
To avoid the damage caused by the overbending of the inlet hose .
When connecting the water hose and the water tap, do not wear the screw.
Please check the inlet hose conditions regularly. Please replace it in time if damaged.
When connecting the screw thread of the inlet hose and the inlet valve, prevent the
screw thread screwed incorrectly or it will wear or leak.