Campomatic FH200 - Manual (Page 4)

4
2.4 Turn the heat select switch to “O” position, the heater stops
working, the indicator light will be off.
3. Adjust the thermostat switch to suitable position for desired
temperature setting.
3.1 Check if the thermostat switch is on the maximum position.
3.2 When you feel the room temperature comfortable, turn the
thermostat switch anti-clockwise slowly to the minimal
position until the appliance stops working.
3.3 Then the thermostat switch will keep the room temperature at
the desired temperature automatically.
3.4 You can also turn the thermostat switch anti-clockwise to the
minimum position or turn the thermostat switch clockwise to
maximum position to make the temperature lower or higher.
Security System
1. To avoid risk to human being or damage to internal
components, the fan heater has a security system which will
automatically switch off the appliance if the heat reaches the
safety limit. If overheating occurs:
1.1 Turn the heat select switch to “O” position, turn the thermostat
switch to the minimal position and remove the plug from the
socket.
1.2 Check if the air flows smoothly before the outlet and inlet, and
if the appliance is put in right position. If so, get it in order
before restart the appliance.
1.3 Let the fan heater cool down for 8 to 10 minutes before you
start it again.
1.4 Plug in the appliance and switch it on. If the appliance can’t
operate normally, remove the plug immediately from the
socket and have the fan heater serviced by an appointed
service only.