Cabasse PHI SYSTEM - Manual (Page 10)

e n g l i s h
ADJUSTING OF THE SANTORIN 21 ACTIVE
SUBWOOFER
0
Take care of positioning the sector switch 115V/230V A on the
right position according to your country.The ON/OFF switch
B (located on the back) of the subwoofer has 3 positions:
ON
AUTO Automatic, the system is put automatically on ON or
OFF according to the presence of signal coming from the AV
amplifier. Put the switch ON/OFF on AUTO or ON position.
OFF
■ CROSSOVER: adjust the C potentiometer on 140 Hz for 2.1
configuration and 180 Hz for the 5.1one.
■ VOLUME: the adjustment of the volume D will depend
upon room positioning, type of amplifiers… With PHI SYS-
TEM the average position is on a “12 AM” position. For an opti-
mum adjustment of the volume, we advise you to carry out it
starting from a stereo source (CD). Then use the SET UP PRO-
CESS of your AV amplifier to adjust the level of channel SUB-
WOOFER/LFE.
■ PHASE: usually it is necessary to position the E switch
on 0°, however 2 positions can be used 0° and 180 °.
- adjust the E switch on 0° when the subwoofer and the front
speakers are positioned at the same distance of the listening
area.
- adjust the potentiometer on 180° when the subwoofer is
positioned 5 ft (1.5m) ahead or behind the front speakers.
SETTING YOUR AV AMPLIFIER -
The table below shows the specific adjustments to be entered dur-
ing the setup of the AV receiver : After having selected the "ON"
option for the use of the subwoofer in the setup menu, select or
enter 140 Hz as the upper cross-over frequency for the subwoofer.
WEEE MARK
Disposal of Wastes of Electrical & Electronic
Equipment (Applicable in the European Union)
This symbol on the product, consisting of the crossed-out
wheeled bin, indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the appli-
cable collection point for the disposal of electri-
cal and electronic equipment at the end of life. By
ensuring this product is disposed of correctly, you
will help prevent potential negative consequences
for the environment and human health, which could otherwise
be caused by inappropriate waste handling of this product. The
recycling of materials will help to preserve natural resources. For
more detailed information about recycling of this product, plea-
se contact your local city office, your household waste disposal
service or the shop where you purchased the product.
PHI SYSTEM ® Position Installation Ways Drivers Sensivity Cross-Over Phase Frequency Nominal Minimum Power Peak Dimensions (h x w x d) Weight Wall
Co-axial Midrange- 1W/1m points response impedance impedance handling power (cm) (kg) mount
Midrange-Tweeter Woofer (dB) (Hz) (Hz) (ohms) (ohms) (W) (W) (in) (lb) accessories
DOM24 / 10T15
PHI Speaker floorstanding 2/5/6/7 2.5 SOFT DOME/P2C* 10T15 P2C* 93 680-3,100 - 140-22,000 8 3.4 100 700 111 x 24 x 24 10 -
column channel system 2.6 cm / 10 cm 10 cm/4 in 43,7 x 9,5 x 9,5 22
1 in/4 in
DOM24 / 10T15
PHI Speaker on/under TV 2/5/6/7 2.5 SOFT DOME/ P2C* 21TMT3 93 680-3,100 - 140-22,000 8 3.4 100 700 44 x 16 x 11.2 4.5 included
centre/on wall on wall channel system 2.6 cm / 10 cm 21 cm/8 in 17.3 x 63 x 4.4 10
1 in/4 in
Santorin 21 floorstanding subwoofer 1 - 21 active adjustable adjustable 35-200 active active 250 750 33 x 33 x 35,6 11.5 -
0°-180° 13 x 13 x 14 25
PHI SYSTEM ® TECHNICAL FEATURES
*P2C diaphragm : Polymer loaded in Calcium Carbonate
Speakers AV amplifier
adjusting
FRONT LEFT SMALL
FRONT RIGHT SMALL
CENTRE SMALL
SURROUND LEFT SMALL
SURROUND RIGHT SMALL
SUBWOOFER/LFE ON / 140 Hz
ACTIVE SUBWOOFER SANTORIN 21
Pulsed sound pressure 114 dB
Phase switch 0° normal
180° reverse
In put 2 low level - 2 hight level
Voltage 115 / 230 V AC-50 / 60 Hz
Maximum power consumption 165W
Standby power consumtion 0.49W @ 230VAC
0.5W @ 115VAC
Power consumption when off 0.04W @ 230VAC
0.04W @ 115VAC
Useable temperature range +5°C to +35°C
Storage temperature -5°C to +40°C
Useable humidity range 40% to 70%
OK-noticePHI-D2:OK-noticePHI-D2 07/12/09 12:36 Page10