Burst Electronics MCG-3 - Manual (Page 46)

45 MCG-3 Color Micro Character Generator
S S S S SI S I S I S I S I SET I ET I ET I ET I ET ID D D D D
PURPOSE: Sets the network ID code for the unit.
FORMAT: S S S S SI,xx I,xx I,xx I,xx I,xx (hex)
xx = 01 to FF
DESCRIPTION: Used to set the ID of each unit when multiple units
are on the same RS232 port. If only one unit is on the RS232 port, set
the ID to 01 (factory default). To set an ID, connect only one unit at a
time to the serial port and set its ID. Note that the W
W W W WA A A A AK K K K KE E E E E command
(W W W W WK,0 K,0 K,0 K,0 K,01 1 1 1 1) must be sent before sending any other command to the unit. It
is possible, although a little risky, to have more than one unit with the
same ID on the same RS232 port; the Set R
Set R Set R Set R Set Resp esp esp esp esponses onses onses onses onses must be off
(S (S (S (S (SR,0) R,0) R,0) R,0) R,0) in that case.
EXAMPLE:
IIIIID,04 D,04 D,04 D,04 D,04 Sets the ID to 04