Burst Electronics Pixie-FS - Manual (Page 4)

source.
7. NTSC/PAL - Selects between NTSC and PAL as
the video input/output.
8. GL On/Off - Selects whether a reference video
source is being used to synchronize the input
video source.
9. S-Video - Selects the type of input video source,
either Composite video or S-Video (Y/C).
Saving Settings
The Pixie-FS will save the settings you have made
automatically. After a setting has been adjusted, let
the Pixie-FS sit for approximately 15 seconds. The
LOCK LED will rapidly flash 5 times when the settings
are being saved. Once the LED goes steady your
settings are saved.
Transcoding
The Transcoding function allows the input video signal
to be converted from either Composite video to S-
Video or S-Video to Composite video. This function is
controlled by both the “Mode #9 S-Video” control and
an internal jumper at JP3. The jumper at JP3
commands the Pixie to output video as either
Composite or S-Video. Transcoding is configured as
follows
Mode #9 JP3 Input Output
Composite In Out-CVS Composite Composite
Composite In Y-Out Composite S-Video
S-Video In Out-CVS S-Video Composite
S-Video In Y-Out S-Video S-Video
Pixie-FS Time Base Corrector 4