BUG-O Systems MDS-1004 - Manual (Page 7)

7
BASIC SETUP
From the Setup Menu (figure 3), the User will select measurement units and which weld
contactors to use, as well as configure the stitch parameters.
From the Main Operating Screen, use button to access the Setup Menu.
Figure 3 Setup Menu.
The following controls are available in the Setup Menu:
Unit selector. Select between English (in) and Metric (mm) units.
Contact selector. Choose which contactor(s) will be used - Drive unit contactor,
Programmable module contactor, both or neither.
Stitch Parameter setup. Configure and save stitch parameters.
Exit. Return to Main Operating screen.
STITCH PROGRAM SETUP
To configure the stitch parameters use button from the Setup menu. The User will be
prompted to set the stitch parameters one at a time. Each setup screen shows the parameter to be
set and its current value. The setup screen for travel speed while welding is shown in figure 4.
Figure 4: Setup screen for travel speed while welding.