BUG-O Systems HOB-O - Manual (Page 6)

6
set-UP aND CUttING
NOte: Heat protection tape is wrapped around magnets (B).
1. Push centering Assembly Slide (C) into center of machine and lock.
2. loosen Pin lock (D) to release Center Pin (e).
3. Allow Center Pin (e) to project beneath base of machine and place in
center-punch mark. “Ride” machine down to the work on the center pin
and be sure it seats firmly on the magnets. The entire machine is now
centered. Do not hammer or you will knock out the alignment.
NOte: Similar procedure locates the HOB-O when vacuum cups or Blind
Area Kit are used.
4. Snug up rack action with Knob (H), so that rack is held firmly but can still
move smoothly in rackholder.
5. When the centering assembly and the torch are fully retracted, the torch
is on center. Thus, a small drilled hole can be used to locate center and as
a starting hole for fast accurate cutting of small holes.
6. Set Rack Stop (f) to desired radius (minus kerf width) and Torcholder
Assembly (G) to desired angle. (Minus kerf width for holes; plus kerf
width for discs or pancakes).
7. Ignite torch (with Shoot-a-lite provided) and pierce hole or start in drilled
starting hole - (IN tHe MateRIaL WHICH WILL Be sCRaP).
8. As soon as the cut is started, switch on travel motor, then rack slowly
until the Rack Stop (f) stops against the back of the rackholder. This
movement will feather the cut into the desired radius without notching.
OPeRatING INstRUCtIONs
f
B
D
e
C
H
G
15
WIRING DIaGRaM / HOB-5100-f DC DRIVe
UNIt
HOB-5100-f 120 VaC
HOB-5102-f 240 VaC
HOB-5104-f 42 VaC
ReD
DK. BLU
DK. BLU
yeL
WH
/BLU
PO
t
M
- a
C
M
+
f
1
2
3
4
5
6
7
8
P
s
PK
Gy
BLK
ReD
M
12
Va
C
t
D
BLK
GRN
BLK
WHt
a
CB
HOB-5102-f 240 VaC
WHt
WHt a
BLK GRN
D
12
Va
C
CB
BLK
t
taN
taN
V
eLeCtRICaL COMPONeNt CHaRt
A Power Cord BUg-9445 gOF-3115 BUg-9442
CB Circuit Breaker BUg-2923 BUg-2952 BUg-2933
D Pilot Light BUG-1415 BUG-1428 BUG-1427
V Volt Trap BUG-1393 BUG-1563 BUG-1393
T Transformer BUg-9675 gOF-3112 BUg-1466
M Gear Motor
F Precision Speed Control
BUG-1725
S Toggle Switch BUg-2255
P Potentiometer Control BUG-9686
PaRt NUMBeR IteM DesCRIPtION
HOB-5100-f
120 VaC
HOB-5102-f
240 VaC
HOB-5104-f
42 VaC
BUg-1550 (150:1)