Broadata Communications 4800 Series - Manual (Page 6)

BCI 4800 User’s Manual
Fiber Optic DVI Extension System
Broadata Technical Support, [email protected] 7
3.0 INSTALLATION
Important: Please use the installation procedure below. Improper,
or no operation may result if the start-up sequence is not correctly
followed.
1. Carefully unpack the contents of the shipping group.
2. With system power turned off, connect the upstream TX module
to the DVI receptacle of the computer.
3. Connect an AC/DC power adapter to the TX module of the 4800.
4. Connect the downstream RX module into the DVI receptacle of
the display.
5. Connect another AC/DC power adapter to the RX module of the
4800.
Note: You might not have to use the AC/DC adapters if power
is supplied from the DVI pin from the graphic card or the
peripherals. After successfully completing the installation
instructions, unplug the adapters one at a time. If the system
doesn’t work properly, the AC/DC power adapter can be
reconnected while the system is on and the video should be
restored. You can then remove one or both power adapters if
not required.
6. Remove the module dust covers and connect each duplex LC
fiber cable one by one as shown in Figure 2-1. Plug 1 to 1, 2 to
2, 3 to 3 and 4 to 4. Carefully recheck polarities and ensure the
duplex connectors are fully engaged.