Broadata Communications LBC-HDBT-Lite-Tx/Rx - Manual (Page 6)

LBC-HDBT-Lite User’s Manual
Link Bridge TM HDbaseT HDMI Transmission System
Broadata Technical Support, [email protected] 7
2.2 Receiver Front and Rear Panels
1. RS-232 Out: Connect to the device that is to be controlled (via
D-Sub 9 pin female cable) by RS-232 commands.
2. IR 1 Blaster: Connect to the supplied IR blaster cable for IR
signal transmission. Place the IR blaster in direct line of sight
of the equipment to be controlled.
3. IR 2 Extender: Connect to the supplied IR receiver cables for
IR signal reception. Ensure that remote being used is within the
direct line-of-sight of the IR extender.
4. HDMI Out: Connect to a HDMI source equipment such as a
DVD or Blu-ray player.
5. Link LED: The yellow LED will illuminate when both the input
and output signals are connected.
6. Power LED: This blue LED will illuminate when the device is
connected to a power supply.
7. CAT5e/6 In: Connect to the receiver unit with a Single CAT5e/6
cable for tranmission of all data signals.