Brinly DTZ-48 BH ZTR Front-Mount Dethatcher - Manual (Page 6)

1009719 Rev E 6.
ASSEMBLY
================================================================================================
Figure 2.
25
25
WARNING:
Failure to install safety wires can result in
personal injury if a tine should dis-engage
from the tine tray.
Bend each end of both safety
wires as shown
NOTE:
Insert each of the two safety wires (25)
through the coils as shown.
Be sure each end is bent completely over the
straight portion of the safety wire.
Figure 3.
5/16” Washer
Qty. 2
26
5/16” Lock Washer
Qty. 2
27
5/16” Hex Nut
Qty. 2
28
5/8” Washer
Qty. 2
31
5/8” E-Ring
Qty. 2
30
5/16” x 1” Carrage Bolt
Qty. 2
24
Wheel and Axle
Assembled
28
27
26
24
30
20
32
33
22
31
23
31
30
19
43
Hand tighten the fasteners used to bolt
the front mount (20) to frame bracket
(19). Install the wheel (23) to the axle
(22) using 5/8” washers (31) and 5/8”
e-ring (30). Insert the nylon bearing (32)
into the top and bottom holes on the end
of front mount (20) with the flange on the
inside.Hold the wheel hub (33) between
the nylon bearings (20) and slide the
axle (22) through the nylon bearing (32)
and the wheel hub (33). Install set screw
(43) into wheel hub (33) and finish the
assembly by installing the e-ring (30) on
to each end of the axle (22).
NOTE: leave the nuts (28) and the set
screw (43) loose for later adjustment
(see Fig 9 and 10)
Two front mount assemblies (20) and
(19) are required see (Fig 4) for orienta-
tion of each assembly and see also
frame bracket (19) install.
Frame Bracket
(19) Install
19
Square