Bompani BOLT945/E - Manual (Page 23)

Tension adjustment
of the door spring
【 】
Figure5
Tension adjustment of the door spring ●
Connection of drain hoses ●
The door springs are set at the factory to the proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to adjust the door spring tension. Rotate
the adjusting screw to drive the adjustor to strain or relax the steel cable(see figure 5).
Door spring tension is correct when
t he door remains horizontal in the
f ully o pened position
yet rises
t o a close with the slight lift of a
f inger.
，
rel ax
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B, C
φ 40mm
A
B
C
Counter Front
Drain pipe
Drain hose hook Close the drain hose hook to the counter
Insert the drain h ose into a drain pipe with a minimum diameter of 4cm, or let it run into the s ink, making sure to
avoid bendin g or crimping it. Use the special plastic suppo rt that comes with the appliance . The top of the ho se
must be at a heig ht between 40 and 100cm. The free end of the hose must not be immersed in water to avoid the
back flow of it.