Dodge 2011 Dakota User Manual
Page 158
Your vehicle should be parked outside of the garage
while training.
• Turn the ignition switch to the ON/RUN position.
• Place the handheld transmitter 1 to 3 inches (3 to 8 cm)
from the HomeLink
buttons while keeping the
HomeLink
display in view.
For optimal training, point the battery end of the
handheld transmitter away from the HomeLink
.
• Simultaneously, press and hold both the chosen
HomeLink
button and the handheld transmitter but-
ton until the indicator(s) change from a slow to a rapid
flash rate.
Then release both the HomeLink
and handheld trans-
mitter buttons.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train.
If the signal is too weak to train, replace the battery in the
handheld transmitter.
NOTE:
Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.
• Press and hold the just-trained HomeLink button. If
the indicator(s) blink rapidly for two seconds and then
remains constant, continue with the next section: “Pro-
gramming A Rolling Code System”.
NOTE:
After training a HomeLink
channel, if the
garage door does not operate with HomeLink
and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading, “Programming A Rolling Code System.”
Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
157