Blu Bathworks LB9010 - Manual (Page 2)

1
1 866 907 0122 blubathworks.com
2014-01
®
Attention — Before Installation
If you are installing this product in a new construction or remodel, please make sure you are following all local plumbing
and building codes. Carefully unpack and examine your new fixture for damage. To help insure that the installation
process will proceed smoothly and correctly, please read these instructions carefully before you begin.
•
We recommend that the installation be done by a minimum of 2 people as a security precaution. Also make sure to
adopt the proper posture when lifting the basin.
• Adhere to all local building and plumbing codes. The diagrams in this guide are not construction plans. They are
visual aids.
• Inspect this product to ensure you have all parts as shown that are required for proper installation. Blu recommends
that the installer refer to the Geberit concealed installation systems instructions.
Note: The bidet faucet, drain and wall carrier for wall-hung bidets need to be purchased separately.
Installation Requirements
Please read the instructions carefully so as to avoid any damage to the fixture.
1. To ensure this product is installed properly, you must read and follow these guidelines.
2. The owner/user of the product must keep this information for future reference.
3. Consult local building codes to make sure the installation complies with standards.
4. Remove the unit from its packaging. Before disposing of it, inspect the unit to make sure its in good shape. Should
inspection reveal any damage or defect in the finish, contact your distributor. The warranty does not cover damages
or defects in the finish once it has been installed. Blu Bathworks’ responsibility for shipping damages ceases upon
delivery of the product in good order to the carrier. All complaints regarding damage due to transport must be made
directly to the carrier.
5. Place the unit in the bathroom before you start working. Conserve all nuts and bolts.
6. To protect the unit during installation, we recommend that you lay a piece of cardboard between the bidet and its
resting surface.
7. If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum
protection. However, remove film where any two surfaces will be in permanent contact.
8. Verify that all dimensions on the plan are the same as the ones of the unit.
Installation Notes
Important! Install this product according to the installation guide. Our products must be installed by certified professionals
only and according to our installation guide as well as federal, provincial / state and local building codes and regulations.
Technical Support Assistance
If further assistance is required, please contact:
Product Support at 1.866.907.0122 (09:00 – 17:00hrs PST) or email [email protected]
North America
Blu Bathworks Inc.
188 Smithe Street,Vancouver, BC, Canada, V6B 6A9
T +1.604.299.0122 F +1.604.299.0125