Blackstar HT-5210 - Manual (Page 11)

the connection of either a single 8 Ohm extension cabinet, the internal loudspeakers
of the HT-5210, or two 16 Ohm extension cabinets. The internal loudspeakers of
the HT-5210 should not be used together with an extension cabinet. See table
below.
HT-5210 Speaker Table ‘1x16 Ohm’ output ‘1x8 Ohm or 2x16 Ohm’ outputs
Internal 8 Ohm speakers X  X
Two 16 Ohm extension cabinets X  
One 16 Ohm extension cabinet  X X
One 8 Ohm extension cabinet X  X
For all other amplifiers in the HT-5 range the output marked ‘1x16 Ohm’ is for
the connection of a single 16 Ohm extension cabinet or the internal loudspeaker
of an HT-5 combo. The outputs marked ‘1x8 Ohm or 2x16 Ohm’ are for the
connection of either a single 8 Ohm extension cabinet or two 16 Ohm cabinets.
Also, the internal loudspeaker of the HT-5 combo can be plugged in here if it is
used with a 16 Ohm extension cabinet. See table below.
HT-5 Range Speaker Table ‘1x16 Ohm’ output ‘1x8 Ohm or 2x16 Ohm’ outputs
Internal 16 Ohm combo speaker  X X
Internal 16 Ohm combo speaker X  
and one 16 Ohm extension cabinet
Two 16 Ohm extension cabinets
X  
Single 8 Ohm extension cabinet X  X
WARNING: The output marked ‘1x16 Ohm’ should never be used at the same time
as either of the outputs marked ‘1x8 Ohm or 2x16 Ohm’.
3. Speaker Emulated Output & Headphones
This output emulates the tonal characteristics of a guitar speaker cabinet and
provides a natural valve overdrive tone for connection to a recording device or mixing
desk, and for use with headphones. To make full use of the stereo reverb, use a
stereo jack to two mono jacks splitter lead to feed two channels of the recording
device or mixer (see diagram below). The output will also function into a mono guitar
type lead. Always use a good quality screened lead.
English
10
Ring
Screen
Tip
Left channel
to mixer
Right channel
to mixer