Beurer MPE 70 - Manual (Page 16)

16
8. cleaning
Important
If the device is only being used by one person, change the paraffin wax at regular intervals and
clean the paraffin bath whilst doing so.
If the device is being used by several people, the paraffin wax should be changed before each
treatment for reasons of hygiene.
• Pull the mains plug out of the socket.
• Take the protective grille out of the paraffin bath.
• Allow the paraffin wax to solidify overnight.
Warning
Do not use any sharp or pointed objects to remove the
wax block from the paraffin bath. You could damage or
scratch the paraffin bath.
• If the paraffin wax has solidified, press on one end
of the wax block and lift it out of the paraffin bath.
If the wax block cannot be removed easily, turn the
temperature controller to “warm” for ten minutes. Then
remove the mains plug and take the wax block out of
the paraffin bath.
• Then wipe the inside of the paraffin bath dry with a
clean towel.
Important
Never fill the paraffin bath with water in order to clean it.
• After cleaning, store the paraffin bath in a cool, dry and
dust-proof place.
9. Replacement parts and wearing parts
Item and/or order number
2 x 450 g of paraffin wax + 30 plastic sleevers 589.42*
* Commercially available or from the corresponding service address (according to the service address list)
10. Disposal
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
11. technical data
Model no. MPE 70
Voltage supply 220-240V~50/60Hz
Output 80W
Protection class II / , IPX0
Dimensions (L x W x H) 33 x 25 x 18 cm
Weight
1 kg